Questions & Answers for: pro gas heaters problems

pro com plaques breaking down Where can I get plaques (#mb19006) for my pro com propane heater(#ml100pa) ? Mine are breaking down causing the heater to back-fire, Pro Com Inc doesn't supply them ?????

gas smell and burns my eyes. im running it on a 20 lb cylinder, could that be the problem or is the valve bad or ????? if it is a part issue, where would be the least expensive site to purchase parts?

...inside the heater. If this does not help you should maybe get a pro to look at it since checking the ign module or the main gas valve involves spectialty tools and a very spefic knowledge. Good

pro propane heater. 1st winter it worked fine. 2nd season i have this problem. a freind said that its because the 30lb tank was to small and i was burning too much vapor in cold temps. so now i have a

Pro-Com Gas Heater Some times the pilot light goes out, flame burns a nice blue color. im afraid to go to sleep with hreater on Many times the thermocouple will build up so corrosion where it seats ...

...pro propane heater will not stay lit for over thirty seconds after I release the red fuel start button,before the flame goes out it makes an air hissing noise right before it shuts off.Heater will ...

...Pro 30,000 btu forced air heater, it will not remain lit unless the gas valve is held constantly. What are the likely problems and where might I find parts I live in Pittsburgh PA The heater will ...

...gas control valves from operating correctly, usually triggering safety shut off.Ask question on pro water heater forum, which has response for bleeding ...

...Pro torpedo heater ran by propane tanks. I can't get it to come on. U can hear the igniter igniting but can't get it to come on. Any suggestions. If gas is being supplied to the heater without ...

...Pro SPC 150T propane heater could be caused by a faulty gas regulator or pressure switch. The gas regulator controls the flow of propane while the pressure switch controls the temperature of the ...