1
Anonymous posted an answer for this Minolta EP1083 CS/PRO Copier:
"Make reset by pressing S1 on Board -A keeping the machine ON"
AnonymousAnonymous posted an answer for this Minolta EP4000/5000 CS/PRO Copier:
"Check scanner board or scanner motor"
Anonymous
Anonymous posted an answer for this Konica Minolta DiALTA Di200 Copier:
"Check heater lamp or thermostat might burn out"
AnonymousAnonymous posted an answer for this Office Equipment & Supplies:
"Put the machine off then turn on the power switch with the stop key held down"
AnonymousAnonymous posted an answer for this Office Equipment & Supplies:
"You might not install the net work card if you did you should inter the setting"
AnonymousAnonymous posted an answer for this Office Equipment & Supplies:
"Put copier off Disconect sorter cable then turn copier on if it work properly put it again..."
AnonymousAnonymous posted an answer for this Minolta EP1031/1031F CS/PRO Copier:
"Clean the mirrors in optical section"
AnonymousAnonymous posted an answer for this Office Equipment & Supplies:
"Reset from S1 on Board -A while the M/C on"
AnonymousAnonymous posted an answer for this Minolta EP4000/5000 CS/PRO Copier:
"See the hopper unit or toner botle"
AnonymousAnonymous posted an answer for this Minolta EP4000/5000 CS/PRO Copier:
"Set the copier into Tech. Rep. mode by pressing the following keys in this order : utilty..."
AnonymousAnonymous posted an answer for this Office Equipment & Supplies:
"Let the copier on then press S1 (reset switch ) on Board-A."
AnonymousAnonymous posted an answer for this Minolta EP4000/5000 CS/PRO Copier:
"1. Turn off copier 2.Disconect finisher cable 3.Turn on the copier . If it works properly..."
AnonymousAnonymous posted an answer for this Konica Minolta DiALTA Di200 Copier:
"On the right side of cotrol panel there is small hole press it with clips .On the screen..."
AnonymousAnonymous posted an answer for this Konica Minolta DiALTA Di200 Copier:
"I need to know m/c model"
AnonymousAnonymous posted an answer for this Office Equipment & Supplies:
"Put toner botle out of its home position then see it goes at home position . If not see..."
AnonymousAnonymous posted a question about Office Equipment & Supplies:
"c-6708 faint copy"
AnonymousAnonymous posted a question about Konica Minolta Office Equipment & Supplies:
"c-6708 faint copy"
AnonymousAnonymous posted a question about Konica Minolta DiALTA Di200 Copier:
"c-6708 faint copy"
Anonymous
Office Equipment &... 15 answers
