Questions & Answers for: Maytag trap error Computers & Internet

...error not letting out the water i checked both outlets all ok sounds a s if you have ablockage within oyour pump assy, remove th elower acess panel and undo the "button trap" your problaby clogged ...

...error code will continue to appear. NOTE: With the clean out trap removed, make sure you check the pump impeller area as well. Small items can get caught in the impeller and restrict the movement. If ...

...wheel bearing on a car.. but no error codes? Very sad to say but i imagine this will either be a trapped item such as bra wire caught in the drum or if it sounds like Gatwick airport when it spins ...

error code will be displayed. ? Check the drain hose and make sure it is not plugged or kinked. ? Check the electrical connections at the pump and make sure the pump is running. ? Check the drain pump

error codes. I cleaned out the drain trap then proceeded to remove the top and rear panels to check the Temperature Sensor. The sensor was tested with an Ohms meter and found to be working properly. I

Error codes. I've changed the pump, cleaned trap, and cleaned the discharge hose. I'm still getting the error codes. Does anyone have anymore ideas? Thanks You did all the right thing,

...goes to an error this is what is known as timing out-you have blockage in your drain-clean the trap if applicable and check the hoses from the tub to the pump and the pump out the back-cheers ...

...error, along with F9 E1. Pulled some coins and nails from the trap, but the problem persists. It is not likely the drain pump is the problem, it more likely the circuit board that controls the cycles ...

what does F7E1 mean on a maytag 2000 series washer water flow error. Clear out trap under front panel. This will allow washer to run. Also drain will improve

...error can be related to foreign objects in discharge pump trap. Checking the area called the coin trap is not a bad idea. Unplug the washer before checking the temperature sensor. The sensor is ...