Questions & Answers for: Geo strobe error Computers & Internet

1993 geo metro timeing is off Get a strobe timing light, hook the aligator clamps to the battery and the C clamp to the #1 spark plug wire. This makes the lamp flash every time #1 plug fires. Point it

...of the correct ignition timing setting. I would first suggest you have the timing checked with a strobe light. Look in your hand book or the label under the bonnet for the correct timing advance. ...

...crank speed. if the engine RPM is 400 , the Alternator will give UP. so first engine RPM 800 then i strobe the alt pulley, oops belt slips, mine runs at 1.8 ratio or 1400 rpm at alt pulley. for a DIY ...

The over drive light keep flashing on my1993 geo prizm this is in the op guide, (glove box ) and in the Priszm FSM. lots to cover, but here in one word the transmission controller is no happy. (errors

locate speed sensor gsi there are more than one. one in speed case. on in transmission. why not say what is not working so we have a clue. and not zero input. eg, tranny error codes. and tranny malf. ...

...2:cam timing is now way off causing #1 , 3: Dizzy timing is way off now, a 1 minute test with the strobe light. and bingo, gee i never to tuneup and the belt is gone. ...

my 96 tracker starts sometimes and not others have replaced alot of parts and battery what could it be Air, spark, and fuel are all needed for combustion and timed at the correct moments and ...

...error you get. here ill answer for CRANKS fast, but will not start and then run. has over 50 causes, and 1 to 10 tests. what me to guess,? this car is G16 engine, there is NO CRANK sensors until ...

I need the torque specs for flywheel to crankcase bolts,97 geo tracker sport, convertible Manual Transmission flywheel torque is 58 Ft pounds. Automatic flex plate is 47 Ft Pounds. its here, for 10 ...

error 2, by OP is using a scanner to set static timing.

the ECU assumes you set it correctly! static
then adds the ECU calculated advance.
here is the equation in algebra.
total time