Questions & Answers for: error code danby Dehumidifiers

...error code displayed, you will probably have to replace the sensor. The humidity and temp sensors are located on the same board. To access it, remove the water bucket and you will see the 2 screws ...

...code for defrosting. Once it's done defrosting it should start operating normally again. If you get the error P1 it is because it is in defrost mode and and if it lasts for a long time clean your ...

...Error codes of P1 show up on the screen at different times and I can't figure out what's wrong. the unit has been plugged directly into the wall in the same outlet it's been in for the last year It ...

error code on danby dhcc6020, its new out of box. tried danby service rep. , cant get a response back from them. any ideas on how to fix? Danby's Consumer Help Line (1-800-263-2629) is always busy. So

...error code on screen. Please can you help me. Check the wiring that runs below the fan for nicks and cuts. I had this error code and was in the process of junking my dehumidifier when I noticed the ...

...CODE ERROR My DANBY Dehumidifier model DDR4588EE has been working ok until itshowed a E1 error code and since then it does not work properly. Anyideas please? E1 code for the primary humidity sensor ...

...Error Code, indicates that the front cover of the unit it no properly in place and making contact with it's removal sensors. Remove and reinstall front cover properly. Be sure to turn the Master ...

...error code indicates that the air intake filter needs to be removed and cleaned. Be sure to turn the unit OFF & unplug it before removing the filter. Never operate the unit without the filter in ...

...code came back E2 Hi There, The E2 error you are receiving is likely the float switch sensor when turns the system off when the bucket is full.   Please contact our customer service ...

...error code. When you plug it in, the transfer pump comes on for a few seconds then stops for a second then runs constantly until you unplug it. Any ideas? sounds to me that you need a new pump in ...