Questions & Answers for: Hunter error 104 Computers & Internet

Error Message RE CO on Indiglo I woke up this morning and the indiglo was flashing RE CO. The other problem is that in the winter the heater never reaches the desired temp. I have the thermostat set ...

Hunter 44360 thermostat This morning REC CO error was flashing and the temperature was at 64? -- what is the error message and how to avoid it in the future. The message means the tstat was in ...

My thermostat displays E What does that mean? Hi, that is the indication for "Error" and you should first replace the (2) AA batteries in the thermostat, (even if you just replaced them recently) and ...

Dual Dimmer / lights go off when fan not on high. I installed a hunter dual dimmer switch. It controls two different fans / lights. When wired, the lights will only come on and dim properly only if ...

...the RET/CLEAR key until the Filter flashes and it clears the counter. I just found it by trial and error. I wrote it inside the cover so I could

just says error 104 I had this happen twice. Pull one battery and wait a few minutes.  The display will fade away.  Re-install the battery and re-program if necessary.

...is missing the RED wire that goes to the fan red wire. The unit will not operate due to a design error. It is my understanding that Hunter is not easily reachable to correct the DESIGN ERROR. ...

...to factory settings and clear all programs, and it should work normally afterwards. If the error occurs again within a month, then call Hunter tech support at 888-830-1326 between 7am - 7pm ...

The "4" only indicates which program is currently running. This thermostat does not display furnace error codes.

In a heating system that uses hot wire ignition for natural gas or propane, this

Programmable Hunter 44150B display has "?" Above heat. What does this mean? The "?" symbol above the "heat" setting on a programmable Hunter 44150B thermostat display indicates that there is a problem