Questions & Answers for: Jeep code 53 Heating & Cooling

Question about 1995 Grand Cherokee

1 Answer

code 53 My jeep Grand cherooke 1995 6 cicle is turnniing of after half an our of a drive and the RPM gage is dansing and it turns off , I chek the car electronically and it seems like it is Code 53 . ...

Ad

Question about 1995 Grand Cherokee

1 Answer

code 53 can u tell me what is coide 53 error in jeep grand jerokee 1995 6 cicle engine isd Hello yeremya1776, For Jeep Grand Cherokee, 1991-95 models: Code 53 - Internal Controller Failure - Internal ...

Ad

Heater diagnostic codes (2000 jeep grand Cherokee) I ran the heater diagnistic and I got 3 codes: 49, 53, 56. can you tell me what they mean? Thanks 49- dimming input is in error 53-door range travel ...

...cherokee runs poorly, check flickers on and off , computer code 53 Code 53 is an internal PCM (engine computer) failure and will require the PCM to be replaced. A rare problem to have,

Question about 2001 Grand Cherokee

1 Answer

jeep w j fault codes 22 52 53 54 56 These codes are out of the AZC HVAC system. they indicate failure of motors and or doors in the heating and a/c system. not an OBDII related system

Code 53 PCM failure or Code 54 no cam shaft position sensor signal from distributor etc, etc.Try this and send us this fault code to send you additional detaild.Hope this helps; also keep in mind that

Code 53 PCM failure or Code 54 no cam shaft position sensor signal from distributor etc, etc.Try this and send us this fault code to send you additional detaild.Hope this helps; also keep in mind that

Question about 2003 Grand Cherokee

1 Answer

...53 plate WJ Jeep Grand Cherokee 2.7CRD auto. It has the engine light on and was jumping in and out of limp mode. Now it seems to be constantly in limp mode and no diagnostic equipment locally will ...

...code 53 any one got any ideas how to sort the problem out ? Hi, Have you a definition for the code by any chance?. 99 per cent of the time the code will be caused by the wiring under one of the front ...

...53 psi at the fuel rail.replaced crankshaft sensor,cam shaft sensor,map sensor,new computer jeep will crank over but wont start sputter cough nothing at the end of my rope just a couple thoughts. ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...