My think your error C0F32:
Faulty
ATDC Sensor E1
The
value of data read by E1 is faulty. [E1 reading is 7% or
less
(3.92V or more) or 19% or more (1.41V or less).]
Are PJ40, CN50, CN17, and PWBA
PJ15A connected properly? (NO) Connect them properly.
Is the CN50 connection dirty?(YES)YES Clean.
Is “C0F32” or “C0F33” displayed
even when an I/C with the same T/
C as that of a new one has been
installed?(NO)Change the I/C with a new one.
Is “C0F32” or “C0F33” displayed
even when an I/C with the same T/
C as that of a new one has been
installed and an F8 operation run?
(Be sure to record the ATDC control
voltage setting value if an F8 operation
is to be run.) (YES) Change PWB-A, install the old I/C,
and return the ATDC control voltage
setting to the value recorded. If
“C0F32” or “C0F33” redisplayed,
change the I/C with a new one. (NO) Change the I/C with a new one.
if you are not tech pleas call your tech service.
812 views
Usually answered in minutes!
Could this code be COF32? No fo32 in my manual
×