Python remote start

SOURCE: i have a python sst car alarm

usually a combination of 2 buttons so the car doesnt start accidentally.

Depending on the number of output channels - the installer could have installed on any of the channels and that would dictate which buttons to press.

if it is not set on the AUX (output 2) button, then try...

1. Lock + unlock at the same time - output 3
2. * + AUX at the same time - output 4
3. Lock + Aux at the same time - output 5
4. Lock + * at the same time - output 6

You have not given the model # of the unit - so these are viper's STANDARD remote controm configurations.

CLICK HERE to enter your correct model # and Download your instruction manual.

Hope this helps.

Thanks for using FixYa - a FixYa rating is appreciated for taking the time to answer your FREE question.

SOURCE: When I start my car using my 950 Python auto start

Does your vehicle surge at all when its running becuase if the Python see's any fluctuation in RPM it will kick out.

SOURCE: The remotes for my system do not operate when I

The "pair" the remote with your system:

1.PRESS AND HOLD the f button on the remote UNTIL the transmit LED lights solid (approximately 10 seconds)
2.PRESS AND HOLD the remote start button (circle arrow) UNTIL the LED blinks 3 times and the amber transmit LED lights up. Your remote is now ready to pair.
3.. Turn the key to the on position
4.Within 5 seconds PRESS AND RELEASE the control button on the antenna.
5. Within 5 seconds PRESS AND HOLD the control button. The status LED will flash one time and the siren will chirp to confirm that the system is ready for remote pairing.
6. Press lock button on remote. System will respond with chirp toconfirm pairing.

SOURCE: How to reprogram Python 4Button Remote 474P ?

I had the exact same thing happen with my 4-button 474p remote. WITHOUT REMOTE START the correct sequence is:

1. Enter car - Leave door open.

2. Turn key to "on" position.

3. Within 5 (five) seconds press the Valet button 7 times then hold down. (Programs to channel 7)

4. Watch alarm light - It should now flash 7 times.

5. While still holding down the Valet button - Press the "lock" button on the remote and release. Should get a "chirp"

6. Now release and repress the Valet button once, holding down. You'll get the "chirp". Release Valet button.

7. Turn key "off". Exit vehicle and test remote. All 4 buttons should now work.