My photocopier e studio e 166 shows the same .how can i outcome fr this problem, and how can i strt copying the wrench icon always blow at the machine
Thank you Andy Bell ...
you saved the day
Kind Regards
Peter
Error code f14 is counter reading missmatch . powerOn in 08 mode and type 388 press enter restart machine its ok or check sram
Hello; I believe your copier need PM that's mean you need replace drum, cleaning blade and developer at lease, after that doing simulation as follow;
press "0"&"8" key while turn on, enter 251 then pree enter, press 0, press enter. turn power off and back on again.
SOURCE: Toshiba E-studio 166
if you turn off the machine and then turn it back on whilst holding down the 1 3 and star button all together it shoul reset any small errors you have on the machine.. good luck A
SOURCE: Hello, I turn on my Toshiba E-Studio 166 Photocopy
Poor contact of the fuser drawer connector may cause the following
error codes: C41~C46, C4A, CD5, E01, E03. To correct this issue, a
spacer (see SPL p25 item 1 attached) has been added between the
fuser connector and the frame; also the springs (see SPL p24 item 8
attached) have been changed to provide more tension.
This change has been applied since January 2003 production:
e-Studio 550 TA314824
e-Studio 650 WA312627
e-Studio 810 XA311627
Model P-I Before Change After Change
e-ST550 25-1 --- 6LA14365000
e-ST650 SPACER-DRW-CNCT
e-ST810 24-8 6LA08946000 6LA14468000
SPC067-070-140 SPC068-080-160
263 views
Usually answered in minutes!
×