...and then turns off. I've unplugged it and let it cool down, but no change. Do you have any ideas? DM module needs repair = replace bad capacitors ( bulged tops) with four 1000mf / 25v
...DM module. it is the board located in the metal case to the left hand side of the chassis( looking from back). VERY DELICATE BOARD BE VERY CAREFUL and make sure to check and the polarity of the caps ...
DM module. Also someone else has said the chassis needs to be rebuilt. What do you think of this? the DM is the board that has the cable card slot on it. to get to it you have to take out the chassis
Question about WS-65869 65" Rear Projection Television
...DM module is a small power supply circuit board which needs to have all five electrolytic filters replaced. The filters are typically 1000 micro farad at 25 volts and are easily obtained by you local ...
...DM module is a small power supply circuit board which needs to have all five electrolytic filters replaced. The filters are typically 1000 micro farad at 25 volts and are easily obtained by you local ...
...dm module put in. TV does not show device menu when I push remote. This set like most of them has a reset--yours has a soft and a hard reset----try the soft reset first-- (with set on) Menu, 1,2,3 ...
...no blinking lights. just turns off. i have already replaced the capacitors and fuses in the DM module. it didn't help. The DG1U "relay i think" makes a clicking sound, then the TV turns off
Question about WS-73909 73" Rear Projection Television
dm module. Where can I get it repaired or replaced? If this is for the green blinking light issue, you can easily fix yourself if you have a soldering iron. It is just a few capacitors. But if you can
Question about WS-73909 73" Rear Projection Television
...dm 10 studio, new, buy it two months ago, when I lit the first time everything worked normal one day move from place to turn on the kit and showed me this message in the module "Calibration fail try ...
...tv then pluged it back in an waited but the light kept flashing. I also tryed the reset button,but the light kept flashing. Likely has bad 1000UF capacitors on DM module. this will prevent
Usually answered in minutes!
19,136 Questions
12,215 Questions
7,310 Questions
7,276 Questions
5,470 Questions
